# Version 1.3.2 build 190919

## **Known Bugs in Karamba3D 1.3.2 build 190919**

* The cross section area of Australian CHS sections in the Karamba3D cross section library is up to 10% too small.
* The 'sig-max' and 'sig-min' output of the Utilization-component for circular hollow cross sections is too large and too small respectively if the resultant bending moment is not acting in local y- or z-direction of the cross section.
* Calculation of mass of shells with varying cross sections is wrong.
* Strain- and temperature loads get ignored in the procedure of the 'Large Deformation Analysis'-component.
* For beams with eccentricities wrong cross section forces result in case the local and global directions of eccentricity do not coincide.

## **New in Karamba3D 1.3.2 build 190919**

Updated the matrix solver for maximum performance on new Intel CPUs.